HHO Truck kit HS 16 000-24V

HHO Truck Kit HS 16 000 is a Plug’N Play are easy and quick to install and can be fit­ted to any diesel truck or bus with­out any engine mod­i­fi­ca­tions or tam­per­ing of the fuel man­age­ment or elec­tri­cal systems.
No com­puter soft­ware, pro­gram­ming, set­ting up, tim­ing or mix­ture adjust­ments are required to the vehi­cle
Fuel-saving sys­tems have built-in: fully auto­matic start, auto­matic stop and auto­matic safety shut­down con­trol thanks to our Dynamic PWM for diesel 24V, which is included in this system.

Com­pact, easy to install
High qual­ity components
Fully auto­mated Ampere lim­iter built-in
No run on after shut­down
No backfire
Adjustable power ranges
Water level sensor
More than 3000 km. with one refill
Fully automated

Equipped with Dynamic PWM’s to control the amperes and production of HHO gas depend on the engine RPMs. There is a buzzer installed in the driver’s cabin to alarm when the reservoir needs to be refilled.

Most trucks make approximately 15 000km. per month which at minimum fuel saving 2 liters per 100km is equal to 450L. of diesel fuel saving!

Technical Data of the Dry cell

Dimensions of the HHO cell: 190 mm x 190 mm x 200 mm (incl. the connectors)
Voltage: 24 – 29 VDC (from vehicles battery)
Material: steel INOX 316L SS
Configuration of the plates: – NNNNNNNNN + NNNNNNNNN –
(+ positive, N-neutral, – negative)
Amperage: 3 to 16 Amp
Working surface: 4394 sq. cm
Capacity: up to 8 liters gas per minute
The required ratio of the electrolyte (water-KOH): 5%-15%

The Plug N Play box includes:

#HHO Dry cell -1 pc.
#HHO tank/reservoir 15 liter – 1 pc.
#HHO bubbler – 1 pc.
tubing – 6m.
Wires:
Red 6 sq.mm. – 3.00 m
Black 6 sq.mm. – 2.00 m
Blue 1.5 sq.mm. – 3.00 m
fuse and fuse holder – 30 amps -2pc.
Inlet gas connector – 1pc.
All electrical connectors
Installation instruction + scheme
Instructions for use