HHO Truck kit HS 16 000-12V

Hydrogen system specially designed for American trucks with Diesel engines up to 16 000cc engine displacement and a 12V charging system.
Plug N Play – Easy to install and fully automated system, which saves up to 25% fuel and reduces emissions up to 78%

Description

Hydrogen system HS 16 000-12V is designed for American trucks with a 12V charging system. This is a Plug’N Play system, which is easy to install behind the cabin in any diesel truck. Does not need any engine mod­i­fi­ca­tions or tam­per­ing of the fuel man­age­ment or elec­tri­cal systems.
No com­puter soft­ware pro­gram­ming, set­ting up, tim­ing or mix­ture adjust­ments are required on the vehi­cle.
This Hydrogen sys­tem has a built-in auto­matic start & stop function, auto­matic safety shut­down, regulates the production of Oxy-hydrogen gas based on the RPMs of the engine.

Easy & Quick installation
High qual­ity components
Fully auto­mated Ampere lim­iter built-in
No run on after shut­down
No backfire
Adjustable power ranges
Water level sensor
More than 3000 km. with one refill
Fully automated

Equipped with Dynamic PWM’s to control the amperes and production of HHO gas depending on the engine RPMs. There is a LED indicator installed near the dashboard to indicate when the reservoir needs to be refilled with electrolyte.

Most trucks make approximately 15 000km. per month which at minimum fuel saving 2 liters per 100km is equal to 450L. of diesel fuel saving!

Technical Data of the System

Dimensions of the system:
in centimeters: H 70 cm x W 50 cm x D 30 cm
in inches: H 28 inch x W 20 inch x D 12 inch
Weight: 45 kg.
Voltage: 12 – 14.4 VDC (from vehicles battery)
Material: Stainless steel INOX 316 Ti
Configuration of the plates: + NNNN-NNNN + NNNN-NNNN +
(+ positive, N-neutral, – negative)
Amperage: 3 to 16 Amp
Working surface: 4394 sq. cm
Capacity: up to 5 liters of gas per minute
The required ratio of the electrolyte (water-KOH): 5%-15%

The Plug N Play system includes:

#HHO Dry cell -1 pc.
#HHO tank/reservoir 15 liter – 1 pc.
#HHO bubbler – 1 pc.
tubing – 6m.
Wires:
Red 6 sq.mm. – 3.00 m
Black 6 sq.mm. – 2.00 m
Blue 1.5 sq.mm. – 3.00 m
fuse and fuse holder – 30 amps -2pc.
Inlet gas connector – 1pc.
All electrical connectors
Installation instruction + scheme
Instructions for use

Additional information

Weight 45 kg
Dimensions 50 × 30 × 70 cm